TM 9-4520-271-14
0022 00
ASSEMBLY
Continued
11. Hold selector valve (10) in left hand with half-moon shaped handle stop on top and proceed as follows:
a. Look in right side opening to ensure that valve is open to that side.
b. If it is not, use handle to turn valve stem 180 degrees (3200 mils).
12. Apply sealing compound (item 17, WP 0061 00) to male threads of elbows (2 and 12) and straight connector (13).
13. Place selector valve (10) in soft-faced vise and install elbows (3 and 12) and straight connector (13). Remove selector
valve (10) from vise.
14. Install selector valve (10), with half-moon shaped handle stop on top, on rear panel (11) and install nut (9).
15. Install selector handle (7) and screw (8).
16. Install quick-disconnect coupling (4), lockwasher (6), and nut (5).
17. Apply sealing compound (item 17, WP 0061 00) to male threads of elbows (3 and 2).
18. Install elbow (3) onto quick-disconnect coupling (4).
19. Install tube assembly (1) onto elbows (3 and 2).
0022 00-8
