TM 9-4520-271-14
0054 00
INSTALLATION
WARNING
Edges of sheet metal can be sharp and cause injury to personnel. Gloves are required when handling the
heat exchanger assembly.
NOTE
Two people are required to install the heat exchanger assembly.
1.
Install heat exchanger assembly (30) through top of ASH, flex rear panel outward, and engage sight tube (32) and
exhaust pipe (31) into rear panel assembly.
2.
Gently position heat exchanger assembly (30) and rear panel assembly and guide heat exchanger forward against front
mounting location. Support front of heat exchanger assembly (30) and aline mounting holes and install two screws (6),
four washers (5), two lockwashers (4), and two nuts (3).
3.
Install support (29) with three screws (28), six washers (27), three lockwashers (26), and three nuts (25).
4.
Install washer (24), lockwasher (23), and screw (22).
5.
Install support (21), two screws (20), four washers (19), two lockwashers (18), and two nuts (17).
6.
Refer to WP 0022 00 and perform Installation steps 1 thru 3 and 5.
7.
Install three each brackets (16 and 15), three screws (14), six washers (13), three lockwashers (12), and three nuts (11).
Handtighten only.
8.
Install three screws (10), six washers (9), three lockwashers (8), and three nuts (7). Handtighten only.
0054 00-9
