T M 9 - 4 9 3 1 - 3 8 1 - 1 4 & P -2
FRAME 10
Install Connector P3:
1.
Measure and cut four 1-inch pieces of new MIL-1-23053/5-102-0 sleeving (1) and
six 1-inch pieces of new MIL-1-23053/5-103-0 sleeving (1) with rule and knife.
2.
Slide sleeving (1) on wires (2).
3.
Using crimping tool and positioner, crimp new electrical
4. Push wires (2) and contacts (3) in new connector P3 (4).
contacts (3) on wires (2).
5.
Slide sleeving (1) over terminals (5). Using thermal gun, shrink sleeving (1).
6.
Tie wires (2) with lacing tape (6). Take tube assembly (7) out of tray and set on
clean work surface.
Follow-on Maintenance:
NOTE: To install electron tube assembly and clamp, refer to task 14.
TASK 6 ENDS HERE
Volume IV
2-176
Para. 2-8, Task 6
