TM 9-4931-381-14&P-2
FRAME 1
Remove Chassis Assembly:
WARNING
High voltage is used in the operation of this equipment.
Death on contact may result if personnel faiI to follow
procedures Iisted.
CAUTION
Make sure connector (1) is unplugged from 115 V ac source
and power supply (2) is set to OFF before disconnecting W10
cable (3) from TSTS (4) to prevent damage to the TSTS (4).
NOTE
Read paragraph 2-4 on removing electrical components
before doing any work.
1.
Make sure TEST SET POWER switch (5) is set to OFF.
2.
Set power supply ON/OFF switch (6) to OFF.
3.
Unplug connector (1) from 115 V ac source.
4. Disconnect W10 cable connector P1 (7) from test set connector J13 PWR IN (8).
GO TO FRAME 2
Volume IV
2-6 Change 1
Para. 2-5, Task 1
