T M 9 - 4 9 3 1 - 3 8 1 - 1 4 & P - 2
TASK 10. Repair IDU Cable Assembly.
Applicability: All Models
Common Tools:
Knife, pocket
Pliers, diagonal cutting
Screwdriver, cross tip, No. 1
Set, soldering and resoldering
Wrench, combination, 1/8-inch
Wrench, combination, 3/16-inch
Special Tools:
Gun, thermal, 8031088
Maintenance Kit, electrical connector repair, 12285360
Supplies:
NOTE:. Expendable supplies are defined in volume 1, appendix C.
Insert, screw thread (96906) MS122119 (as required)
Insert, screw thread (96906) MS122116 (as required)
Lockwasher (96906) MS35338-135 (as required)
Lockwasher (96906) MS35338-136 (as required)
Pencil, writing (Item 19)
Sleeving, insulation (Bulk)
Solder (Item 29)
Tag, marker (as required) (Item 34)
Personnel: One
Equipment Condition:
Thermal system test controlIer on a clean work surface.
Preliminary Procedures:
1. Remove thermal system test controlIer case cover; refer to volume 1, para. 4-17.
2. Remove thermal system test controlIer; refer to para. 2-5, task 2.
3. Remove IDU assembly A2; refer to task 1.
4. Remove cover; refer to task 2.
5. Remove circuit card assemblies A1 and A2; refer to task 3.
6. Remove power supply; refer to task 4.
7. Remove electron tube assembly and clamp; refer to task 5.
8. Remove IDU cable assembly; refer to task 9.
Volume IV
Para. 2-8, Task 10
2-185
