T M 9 - 4 9 3 1 - 3 8 1 - 1 4 & P - 2
FRAME 15
Repair Connectors W1P3, W1J1, or W1J2:
1.
2.
3.
4.
5.
NOTE
Read paragraph 2-4 on repairing connectors and tagging
wires before doing any work.
Use this procedure to repair electrical plug connector
W1P3, or receptacle connector W1J1 or W1J2.
To replace receptacle connector W1J3, do frames 14
and 15.
To replace terminal Iug, do frame 16.
To replace terminal Iug or electrical-mechanical post
do frame 17.
To replace bracket, do frames 18 and 19.
To replace receptacle connector W1XA1 or W1XA2, do
frame 20.
To replace electrical bracket, do frames 21 and 22.
Using removal tool, take out bad contact (1) from connector (2).
Cut off bad contact (1) with pliers. Get rid of contact (1).
Using stripping tool, strip wire (3).
Using crimp tool, put new contact (1) on wire (3) and crimp.
Using insertion tool, put contact (1) in connector (2).
NOTE
If repairing connectors W1P3, W1J1, or W1J2 only, go to
follow-on maintenance, and TASK 10 ENDS HERE.
GO TO FRAME 16
Volume IV
2-186
Para. 2-8, Task 10
