T M 9 - 4 9 3 1 - 3 8 1 - 1 4 & P -2
FRAME 20
Remove Bracket:
1.
2.
3.
4.
5.
NOTE
Read paragraph 2-4 on replacing inserts before doing any
work.
Unscrew and take off two nuts (1) and Iockwashers (2) holding connector W1J3 (3) to
bracket (4) with 1/8-inch wrench. Get rid of lockwashers (2).
Take connector W1J3 (3) off bracket (4).
Unscrew and take off machine screw (5), lockwasher (6), flat washer (7), and
terminal lug (8) from bracket (4) with screwdriver. Get rid of lockwashers (6).
Unscrew and take out two machine screws (9), Iockwashers (10), and flat washers
(11) with screwdriver. Get rid of lockwashers (10). Take electrical (12) off
of bracket (4).
Look at bracket (4) for loose screw thread inserts (13, 14). Replace bad inserts
(13, 14). If OK set aside for later use.
GO TO FRAME 21
Volume IV
Para. 2-8, Task 10
2-191
