T M 9 - 4 9 3 1 - 3 8 1 - 1 4 & P -2
FRAME 22
Remove Receptacle Connector W1XA1 or W1XA2:
NOTE
Use this procedure to replace either receptacle
connector W1XA1 or W1XA2. W1XA1 is shown.
Read paragraph 2-4 on tagging and soldering wires
before doing any work.
Tag and unsolder wires (1) going to connector (2).
1.
2.
Unscrew and take out two mount screws (3), flat washers (4), Iockwashers (5), and
hexagon plain nuts (6) from connector (2) with 3/16-inch wrench.
3.
Get rid of Iockwashers (5) and turn in connector (2).
Install Connector W1XA1 or W1XA2:
4.
Screw in and tighten two screws (3), washers (4), new Iockwashers (5), and nuts (6)
with screwdriver.
5.
Solder wires (1) to new connector (2). Refer to wiring chart, frame 23.
NOTE
If replacing connector W1XA1 or W1XA2 only, go to follow-
on maintenance, and TASK 10 ENDS HERE.
GO TO FRAME 23
Volume IV
Para. 2-8, Task 10
2-
193
