T M 9 - 4 9 3 1 - 3 8 1 - 1 4 & P - 2
TASK 13. Replace TerminaI Lug.
Applicability: All Models
Common Tools:
Bit, cross tip, No. 2
Screwdriver, cross-tip, No. 2
Set, soldering and resoldering
Wrench, combination, 1/4-inch
Special Tools:
Wrench Set, socket, 12285468
Supplies:
NOTE: Expendable supplies are defined in volume 1, appendix C.
Lockwasher (96906) MS35338-136 (two required)
Pencil, writing (Item 19)
Solder (Item 29)
Tag, marker (as required) (Item 34)
Terminal Lug (19200) 12303323
Personnel: One
Equipment Condition:
Thermal system test controlIer on a clean work surface.
Preliminary Procedures:
1. Remove thermal system test controller case cover; refer to volume 1, para 4-17.
2. Remove thermal system test controller; refer to para. 2-5, task 2.
3. Remove power module A6; refer to task 1.
2-250
Volume IV
Para. 2-9, Task 13
