F R A M E 11 Replace Relay (Continued)

TM-9-4931-381-14P-2 Test Stand Automotive Generator Alternator Starter And Associated Equipment Model GASR-500 Manual
Page Navigation
301

T M 9 - 4 9 3 1 - 3 8 1 - 1 4 & P -2 F R A M E 11 Replace Relay (Continued): NOTE If replacing relay K6, K7, K8, K9, K10, K11, K12, K13, K14, K15, or K16, do frames II and 12. Relay K9 is shown. Relay numbers are next to relays on chassis. Read paragraph 2-4 on tagging wires, soldering and installing sleeving before doing any work. Remove Relay: 1. Cut lacing tape with pliers and unsolder wires (1) from relay (2). 2. Cut sleeving 3. Unscrew and nuts (8) with (3) with pliers and unsolder semiconductor (4) from relay (2). take out two screws (5), two Iockwashers (6), four washers (7), and two screwdriver and wrench. Get rid of Iockwashers (6). 4. Take relay (2) out of chassis (9). Turn in relay (2). GO TO FRAME 12 Volume IV 2-298 Para. 2-11, Task 8

Privacy Statement
Press Release
Contact