T M 9 - 4 9 3 1 - 3 8 1 - 1 4 & P - 2
TASK 9. Replace Terminal Lug E1, E2, E4, E5, E6, or E7 and Electrical-Mechanical Post.
Applicability: All Models
Common Tools:
Bit, cross tip, No. 2
Pliers, diagonal cutting
PIiers, long nose
Screwdriver, cross tip, No. 2
Set, soldering and resoldering
Wrench, combination, 1/4-inch
Special Tools:
Wrench Set, socket, 12285468
Supplies:
NOTE: Expendable supplies are defined in volume 1, appendix C.
Lockwasher (96906) MS35338-136 (as required)
Pencil, writing (Item 19)
Post, electrical-mechanical (19200) 12303288 (as required)
Solder (Item 29)
Tag, marker (as required) (Item 34)
Tape, lacing (Item 35)
Terminal Lug (19200) 12303323 (as required)
Personnel: One
Equipment Condition:
Thermal system test controlIer on a clean work surface.
Preliminary Procedures:
1. Remove thermal system test controller case cover; refer to volume 1, para. 4-17.
2. Remove thermal system test controlIer; refer to para. 2-5, task 2.
3. Remove electrical load bank AS; refer to task 1.
Volume IV
Para. 2-11, Task 9
2-301
