T M 9 - 4 9 3 1 - 3 8 1 - 1 4 & P - 2
FRAME 8
Remove Push Switch S1:
1.
2.
3.
4.
5.
GO
NOTE
Read paragraph 3-4 on tagging and soldering wires before
doing any work.
Unscrew and take out six machine screws (1), Iockwashers (2), and fIat washers (3)
from handle cover (4) with cross tip screwdriver. Get rid of Iockwashers (2).
Lift off handle cover (4).
Unscrew but do not take out two screws (5) on electrical cable clamp (6) with flat
tip screwdriver.
Unscrew sleeve nut (7). Slide clamp (6) out of way.
Tag and unsolder four wires (8) from switch (9). Look at probe assembly (10) and
electrical clip (11) for cracks. If probe assembly (10) is bad, turn in. If OK, set
aside for later use. If clip (11) is bad, cut off old clip (11) with pliers and solder on
new clip (11). If OK, set aside for later use.
TO FRAME 9
Volume lV
Para. 3-6, Task 3
3-21
