TM 9-4931-381-14&P-2
FRAME 5.4
Remove Fuse Cannister Decal or Label:
1.
2.
3.
NOTE
Use this task to replace either the decal or label on
fuse cannister (1). Caution label (2) is shown.
Slide protective covers (3 and 4) off cannister (1). Look at covers (3 and 4) for
cracks. If bad, turn in cover (3 or 4). If OK, set aside for later use.
Lift edge of label (2) with knife and slowly pull label (2) off, using knife to scrape
wherever necessary.
WARNING
Isopropyl alcohol is toxic and extremely flammable. Use
only in welI-ventiIated areas. Avoid prolonged or repeated
breathing of vapors.
Avoid prolonged contact with skin.
Keep area free of sparks and open flames.
Clean area (5) using rag moistened with isopropyl alcohol.
InstalI Fuse Cannister Decal or Label:
4.
Peel back off new label (6) and press label (6) on area (5) of cannister (1).
5. Slide protective covers (3 and 4) on cannister (1).
Follow-on Maintenance:
1. InstalI W10 cable in accessory storage assembly: refer to volume 1, para. 4-18.
2. Install accessory storage assembly cover; refer to volume 1, para. 4-18.
TASK 2 ENDS HERE
Volume IV
Para. 3-6, Task 2
Change 1 3-17
