TM 9-4931-381-14&P-2
FRAME 18
Install Chassis Assembly:
Soldier A:
1.
Lay controller case assembly (1) on back.
Soldier B:
Soldier C:
Soldier A:
Soldier B:
Soldier C:
Soldier A:
WARNING
Chassis assembly (2) weighs approximately 136 pounds
(62 kilograms). To avoid injury, two soldiers are needed to
lift or move chassis assembly (2).
2.
Carefully lift and turn chassis assembly (2) by bow handles (3). Set
chassis assembly (2) on case (1) at 45 degree angle.
2.
Connect receptacle connector P1 (4) to chassis assembly (2) with flat
tip screwdriver.
3.
Carefully lift chassis assembly (2) by handles (3) and lower into
case (1).
4.
Screw in and tighten 32 machine screws (5), new lockwashers (6), and
flat washers (7) in panel (8) with cross tip screwdriver.
Follow-on Maintenance:
NOTE: To install thermal system test controller case cover: refer to volume I,
para. 4-18.
FND OF THERMAL SYSTEM TEST CONTROLLER CASE MAINTENANCE
Volume lV
2-30 Change 1
Para. 2-5, Task 8
