T M 9 - 4 9 3 1 - 3 8 1 - 1 4 & P - 2
Remove Connector:
NOTE
l
Use this task to replace any of three plug connectors
J14, J15, or J16. J16 (1) is shown.
l
Read paragragh 2-4 on tagging and soldering wires
before doing any work.
1.
Tag and unsolder wires (2) from connector (1).
2.
Unscrew and takeoff nut (3) and lockwasher (4) with wrench. Turn in connector (1),
nut (3), and lockwasher (4).
Install Connector:
3. Put new connector (1) in hole in panel assembly (5).
4. Screw on and tighten new nut (3) and new lockwasher (4) with wrench.
5. Solder wires (2) to connector (1).
Follow-on Maintenance:
1. Install thermal system test controller; refer to para. 2-5, task 8.
2. Install thermal system test controller case cover; refer to volume 1, para. 4-18.
TASK 15 ENDS HERE
Volume IV
Para. 2-6, Task 15
2-79