T M 9 - 4 9 3 1 - 3 8 1 - 1 4 & P - 2
TASK 7. Replace Electrical-Mechanical Post.
Applicability: AlI Models
Common Tools:
Screwdriver, cross tip, No. 2
Wrench, combination, 1/4-inch
Special Tools: None
Supplies:
Lockwasher (96906) MS35338-135 (as required)
Post, electrical-mechanical (80205) NAS 1786-06-16 (as required)
Personnel: One
Equipment Condition:
Thermal system test controlIer on a clean work surface.
Preliminary Procedure:
1. Remove thermal system test controller case cover; refer to volume 1, para, 4-17.
2. Remove thermal system test controller; refer to para. 2-5, task 2.
3. Remove electrical card holder; refer to task 1.
4. Remove circuit card assemblies A2, A3, A4, A5, A6, A7, A9, A10, A13, and A14; refer
to task 3.
5. Remove digital subsystem assembly A3; refer to task 4,
6. Remove plate; refer to task 5.
7. Remove terminal board; refer to task 6.
2-130
Volume IV
Para. 2-7, Task 7
