TM 9-4931-381-14&P-2
F R A M E 8
Remove Post:
NOTE
Use this task to replace any of 12 posts (1).
1.
Unscrew and takeout 12 screws (2), lockwashers (3), and flat washers (4) with
screwdriver and wrench. Get rid of lockwashers (3).
2.
Take off and get rid of post (1).
Install Post:
3.
Line up new post (1) with hole in terminal board (5).
4.
Screw in and tighten 12 screws (2), new Iockwashers (3), and washers (4) with
screwdriver and wrench.
Follow-on Maintenance:
1. lnstall terminal board; refer to task 16.
2. Install plate; refer to task 17.
3. install digital subsystem assembly A3; refer to task 18.
4. lnstall circuit card assemblies A2, A3, A4, A5, A6, A7, A9, A10, A13, and A14;
refer to task 19.
5. Install electrical card holder; refer to task 20.
6. Install thermal system test controller; refer to para. 2-5, task 8.
7. Install thermal system test controller case cover; refer to volume 1, para. 4-18.
TASK 7 ENDS HERE
Volume IV
Para. 2-7, Task 7
2-131
