T M 9 - 4 9 3 1 - 3 8 1 - 1 4 & P -2
TASK 9. Remove Center Plate.
Applicability: All Models
Common Tools:
Drill, 1/4-inch
Drill Bit, 1/16-inch
Hammer, machinist’s
Punch, drive pin, 1/16-inch
Special Tool: N o n e
Supplies: None
Personnel: One
Equipment Condition:
Thermal system test controlIer on a clean work surface.
Preliminary Procedures:
1. Remove thermal system test controlIer case cover; refer to volume 1, para. 4-17.
2. Remove thermal system test controller; refer to para. 2-5, task 2.
3. Remove electrical card holder; refer to task 1.
4. Remove circuit card assemblies A2, A3, A4, A5, A6, A7, A9, A10, A13, and A14; refer
to task 3.
5. Remove digital subsystem assembly A3; refer to task 4.
6. Remove plate; refer to task 5.
7. Remove terminal board; refer to task 6.
2-134
Volume IV
Para. 2-7, Task 9
