T M 9 - 4 9 3 1 - 3 8 1 - 1 4 & P -2
TASK 10. Replace Isolation Wall.
Applicability: All Models
Common Tools:
Hammer, machinist’s
Pin, drift
Punch, center
Punch, drive pin, 1/16-inch
Special Tools: None
Supplies:
Rivet (96906) MS16535-3 (four required)
Wail, isolation (19200) 12303445
Personnel: Two
Soldier A: Replaces isolation wall.
Soldier B: Helps Soldier A.
Equipment Condition:
Thermal system test controlIer on a clean work surface.
Preliminary Procedures:
1. Remove thermal system test controller case cover; refer to volume 1, para. 4-17.
2. Remove thermal system test controller; refer to para.2-5, task 2.
3. Remove electrical card holder; refer to task 1.
4. Remove circuit card assemblies A2, A3, A4, A5, A6, A7, A9, A 10, A 13, and A 14; refer
to task 3.
5. Remove digital subsystem assembly A3; refer to task 4.
6. Remove plate; refer to task 5.
7. Remove terminal board; refer to task 6.
2-136
Volume IV
Para. 2-7, Task 10
