T M 9 - 4 9 3 1 - 3 8 1 - 1 4 & P - 2
TASK 12. Install Circuit Card Assembly Test or Terminal Board Assembly Test.
Applicability: AlI Models
Common Tools:
Bit, cross tip, No. 1
Pliers, Iong nose
Screwdriver, cross tip, No. 1
Set, soldering and resoldering
Wrench, combination, 3/16-inch
Special Tools:
Wrench Set, socket, 12285468
Supplies:
NOTE: Expendable supplies are defined in volume 1, appendix C.
Lockwasher (96906) MS35338-135 (four required per terminal board assembly)
Solder (Item 29)
Tape, lacing (Item 35)
Personnel: O n e
Equipment Condition:
Thermal system test controlIer on a clean work surface.
Preliminary Procedure:
Remove circuit card assembly TB1 or terminal board assembly TB2; refer to task 6.
2-308
Volume IV
Para. 2-11, Task 12
