TM 9-4520-258-14
5-6. HEAT EXCHANGER ASSEMBLY - continued.
a.
Removal - continued (Refer to Figure 5-12)
WARNING
Edges of sheet metal can be sharp and cause injury. Gloves should be worn when handling the
heat exchanger.
CAUTION
Damage to heat exchanger will result if the last support screw removed without supporting the
assembly. Support the front and rear of the heat exchanger prior to final removal of attaching
hardware.
NOTE
Two individuals are required to remove the heat exchanger assembly.
(8)
One person supports the front end of the heat exchanger (1), the second person supports the rear end
of the heat exchanger and removes screw (2), lockwasher (3) and flat washer (4) from top of frame (5).
Discard lockwasher.
(9)
Remove heat exchanger (1) through rear of unit.
Figure 5-12. Heat Exchanger, Removal
5-26
