TM 9-4520-258-14
5-6.
HEAT EXCHANGER ASSEMBLY - continued.
c.
Inspection
(1)
Inspect all parts for wear, cracks, corrosion, bent or broken terminals.
(2)
Inspect all hardware for stripped or damaged threads.
d.
Repair
Repair limited to replacement of damaged parts.
e.
Assembly (Refer to Figure 5-15)
WARNING
Edges of sheet metal can be sharp and cause injury. Gloves should be worn when handling the
heat exchanger.
NOTE
The top tube of heat exchanger is between the top ends of clamp when properly positioned.
(1)
Install clamp (1), four flat washers (2), two screws (3), two lockwashers (4) and two nuts (5) hand tight
only. Hardware will be tightened during installation of assembly.
Figure 5-15. Heat Exchanger, Assembly
5-29
