TM 9-4520-258-14
5-6. HEAT EXCHANGER ASSEMBLY - continued.
b.
Disassembly - continued (Refer to Figure 5-14)
(2)
Remove six nuts (1), six lockwashers (2), six screws (3) and twelve flat washers (4) from two clamps
(5). Discard lockwashers.
NOTE
Shell must be tilted to allow clearance for the heat exchanger air inlet pipe.
(3)
Remove heat exchanger shell (6) from the heat exchanger (7).
(4)
Remove two nuts (8), two lockwashers (9), two screws (10) and four flat washers (11) and clamp (12).
Discard lockwashers.
(5)
Remove captive nuts (13) only if damaged and replacement is required.
Figure 5-14. Heat Exchanger, Disassembly
5-28