TM 9-4520-258-14
5-6. HEAT EXCHANGER ASSEMBLY - continued.
e.
Assembly - continued (Refer to Figure 5-16)
(2)
Install any captive nuts (1) removed during disassembly.
(3)
Slide heat exchanger shell (2) onto heat exchanger (3) with air inlet pipe (4) aligned with large opening
in side of shell.
(4)
Install two clamps (5) on heat exchanger (3), one on tube 5 and one on tube 7. Secure with eight flat
washers (6), four screws (7), four lockwashers (8) and four nuts (9). Tighten hardware hand tight only,
hardware will be tightened during installation of assembly.
Figure 5-16. Heat Exchanger, Assembly
5-30